Mather, CA

System is operating upon arrival. Kathleen has no issues with her systems or airflow. Both thermostats are responsive when calling for heat. Air handler is located in attic with ductwork and insulation. Ductwork and insulation Look OK, no signs of any defects. Disconnect box and fuses are in good condition. Circuitboard shows no signs of any electrical damage. Reset Lennox communicating system. Blower and evaporative coil are clean. Blower amperage is within range. Evaporative coil produces condensation and all water is drained properly. filter was still in good shape. Heat pump is located to the right of the home. No signs of any electrical damage on circuit board. Disconnect box and fuses are in good condition. Contactor is free from electrical damage. Dual starter is out of range on compressor side and should be replaced. Kathleen agreed. Replaced out of spec starter with a new starter. Ran and tested system. Everything is operating normally. System was left running upon departure.

Replaced the return air plenum to decrease internal static pressure and installed a new thermostat upstairs.

Upon arrival, system is set to off. Symptoms described, or that the thermostat is reading 5° higher than the thermometer in the bedroom; additionally that the airflow feels very weak. Also, the Daikin thermostat is not connected to the Daikin cloud or the Daikin app. Connected Daikin thermostat to app after resetting thermostat. Once system was reset; the thermostat updated. Powered on and it took a few minutes which is likely due to the system being freshly updated. However, once the system did turn on, tested airflow, and temperature temperature split; airflow and temperature split are both good and the thermometers next to the thermostat are both within 2° of the thermostats reading. System is operating properly upon departure.

System is operating upon arrival. Sarah and her husband tell me that they have a concern with water leaking out of the pan up in the attic. I made sure all the condensate water was draining out from the home and it was just not the same drain line that used to leak out the condensate. I went up to the attic to check the system and didn’t notice any water leaking out of the drain pan. They installed the primary drain line to what used to be the secondary drain line for the older system. I did notice that it had a better pitch to drain water out way quicker . The current secondary drain line was connected to the old primary drain line that goes down the home and outside to a proper drainage that Sarah and her husband were used to. System is operating properly and all water is draining properly but Sarah and her husband do not like the fact that the condensate water comes from a different drain line. I let them know that it could be the way this new system is designed versus they’re older

Fix kinked duct.

Client is ready for install.

Quoted 5 ton hp with 3000$ rebate. Install on Monday. Fix kinked duct 12 inch close to attic access. Cut in extra return. Two bags of duct 14 inch and 14x24 filter grill.

Entire condenser replacement complete, pressure is adjusted to manufacturer specs. Replaced the conduit that cracked broken due to a severe UV light, installed a UV protective blanket over line set insulation.

Upon arrival, indoor fan turns on when calling for cool however nothing turns on outside; no contactor is Present. Outdoor control board shows error code L6 Which indicates “open start circuit” which usually applies compressor not functioning properly. Checked capacitor for good measure and capacitor is out of spec. Tried new capacitor and system still not running. Checked compressor ohms and resistance was not adding up which indicates compressor failure. Informed Chad of diagnosis as well as cost of repairs. Have Andrew from warehouse tracking down part.

Put the lineset cover back on

Arrived on site to perform maintenance on a 3 year old system. System powers on when calling for cool at thermostat and presents a 20° temperature split. Blower motor and coil are very clean and in good shape. Washed condenser today. Capacitor on outdoor unit is in spec. Contactor shows no signs of burning or pitting. Both indoor and outdoor board show no signs of burning. Refrigerant is balanced. Drain line is free of backups or debris. Changed April aire 210 filter today and signed up for maintenance program. Tested system after evaluation and system is operating upon departure

Replaced apirlaire 210 filter,